Specifications

34 en | Accessing the Array: Serial Port, Ethernet, and Access Security SCSI to SATA RAID Subsystem | Administrator’s Manual
F.01U.027.802 | V1 | 2006.11 Bosch Security Systems
The baud rate default is 38400. If another baud rate is preferred, press the up or down arrow
keys to select the baud rate, then press ENT for 2 seconds to confirm the selected baud rate.
Set the identical baud rate to your RAID array and your terminal computer.
• The following baud rates are available: 2400, 4800, 9600, 19200, and 38400.
• Terminal connection should work properly using the above setting. You may check the fol-
lowing option in your COM port configuration if you encounter problems:
“Term Emul. Enab ..”: Make sure the terminal function has not been accidentally disabled.
3.1.2 Starting RS-232C Terminal Emulation
The keys used when operating via the terminal are as follows:
Fig. 3.1 RS232C Initial Screen
The initial screen appears when the controller finishes its self-test and is properly initialized.
Use ↑ ↓ arrow keys to select terminal emulation mode, then press [ENTER] to enter the Main
Menu.
← → ↑ ↓ To select options
[Enter] To go to a submenu or to execute a selected option
[Esc] To cancel an option or return to the previous menu
[Ctrl]+[L] To refresh the screen information
i
NOTICE!
If the RS-232C cable is connected while the controller is powered on, press [Ctrl] + [L] to
refresh the screen information. Key combinations may vary depending on the terminal soft-
ware you use.