Specifications

SCSI to SATA RAID Subsystem | Administrator’s Manual Event Messages | en 229
Bosch Security Systems F.01U.027.802 | V1 | 2006.11
Message Controller PCI Bus Parity Errors Detected
What Happens? Serious system faults have occurred.
What to Do? Stop host I/Os immediately to prevent further data dis-integrity and
contact your RAID system supplier.
Message Controller ALERT: Power Supply Unstable or NVRAM Failed
What Happens? Power supply voltage fluctuating or internal system faults have
occurred. Different system faults may trigger this event, e.g., memory
pins contact problems or incongruent firmware versions, etc.
What to Do? Check proper system operation conditions and contact your RAID sys-
tem supplier.
Message BBU Absent or Failed! Correct It and Reset Ctlr to Take Effect
What Happens? BBU (battery cell pack) has failed or is accidentally removed. When a
new module is installed, reset the subsystem for the configuration to
take effect.
What to Do? Check proper installation of the module or contact your RAID system
supplier for a replacement module.
Message Controller BBU Absent or Failed!
What Happens? BBU (battery cell pack) has failed or is accidentally removed. When a
new module is installed, reset the subsystem for the configuration to
take effect.
What to Do? Check proper installation of the module or contact your RAID system
supplier for a replacement module.
Message Controller BBU Failure Detected!
What Happens? BBU (battery cell pack) has failed or is accidentally removed. When a
new module is installed, reset the subsystem for the configuration to
take effect.
What to Do? Check proper installation of the module or contact your RAID system
supplier for a replacement module.