Specifications

SCSI to SATA RAID Subsystem | Administrator’s Manual Event Messages | en 225
Bosch Security Systems F.01U.027.802 | V1 | 2006.11
Notification:
Message Peripheral Set 0 Device ALERT: Temperature Sensor 0 Not Present
What Happens? Temperature sensor failed or serial bus configuration/connection faults
occurred.
What to Do? Contact your RAID system supplier.
Message Peripheral Set 0 Device ALERT: Cold Detected
What Happens? Temperature dropped below the lower system threshold detected.
Improper installation site condition might have caused the situation.
What to Do? Correct your installation site condition. Contact your RAID system sup-
plier.
Message SES(C0 I0)Temp Sensor 0: Device Note Supported!
What Happens? Unrecognizable device type. This event may result from an incorrect
configuration with the SES remote device monitoring.
What to Do? Check proper module installation and contact your RAID system sup-
plier.
Message SAF-TE Device(2) NOTICE: Fan Back On-Line(Idx:11)
What Happens? A once missing or failed cooling fan is restored. This message is
reported through the SAF_TE monitoring device.
What to Do? Press ESC to clear this message.
Message NOTICE: Fan Module A Back On-Line(FAN0 _RPM)
What Happens? A once missing or failed cooling fan is restored. This message is
reported through an I2C serial bus with RPM reading.
What to Do? Press ESC to clear this message.
Message Peripheral Device NOTICE: Fan Back On-Line
What Happens? An I2C serial bus message indicating a once missing or failed cooling
fan is restored.
What to Do? Press ESC to clear this message.
Message Peripheral Set 0 Device NOTICE: FAN 1 Back On-Line
What Happens? An individual cooling fan once missing or failed is restored.
What to Do? Press ESC to clear this message.
Message Peripheral Set 0 Device NOTICE: FAN 1 is Present
What Happens? An individual cooling fan once missing or failed is restored.
What to Do? Press ESC to clear this message.