Specifications

SCSI to SATA RAID Subsystem | Administrator’s Manual Event Messages | en 211
Bosch Security Systems F.01U.027.802 | V1 | 2006.11
Message LG:0 Logical Drive NOTICE: Starting Parity Regeneration
What Happens? Start regenerating parity of a logical drive.
What to Do? Press ESC to clear the message.
Message LG:0 Logical Drive NOTICE: Parity Regeneration of Logical Drive Com-
pleted
What Happens? The parity regeneration process on logical drive _ is completed.
What to Do? Press ESC to clear the message.
Message LG:0 Logical Drive NOTICE: Starting Creation
What Happens? Logical drive creation process started. Note that the creation and initial-
ization processes are separated. Creation of a logical drive only takes a
second while the initialization may take hours with the arrays containing
large capacity drives.
What to Do? Press ESC to clear the message.
Message LG:0 Logical Drive NOTICE: Starting On-Line Initialization
What Happens? Creation process is completed, initialization process has begun to gener-
ate parity sectors and readying member drives. The On-line initialization
mode takes a longer time to complete and allows the logical drive to
receive host I/Os immediately if appropriate host ID/LUN mapping has
been applied.
What to Do? Press ESC to clear the message.
Message LG:0 Logical Drive NOTICE: On-Line Initialization of Logical Drive Com-
pleted
What Happens? Logical drive on-line initialization completed
What to Do? Press ESC to clear the message.
Message LG:0 Logical Drive NOTICE: Starting Off-Line Initialization
What Happens? Creation process is completed, initialization process has begun to gener-
ate parity sectors and readying member drives. The Off-line initialization
mode takes place immediately after the creation of a logical drive, and
does not allow host I/Os to be distributed to the logical drive at the
same time.
What to Do? Press ESC to clear the message.
Message LG:0 Logical Drive NOTICE: Off-Line Initialization of Logical Drive Com-
pleted
What Happens? Logical drive off-line initialization completed. The logical drive is now
ready for host ID/LUN mapping, and then receiving host I/Os.
What to Do? Press ESC to clear the message.