Specifications

SCSI to SATA RAID Subsystem | Administrator’s Manual Event Messages | en 205
Bosch Security Systems F.01U.027.802 | V1 | 2006.11
16.1.4 Controller Events
Critical
ALERT: +3.3V Low Voltage Detected(205.9V)
ALERT: Controller FAN 0 Low Speed Detected(0 RPM)
Controller NOTICE: Redundant Controller Firmware Updated
Controller ALERT: Redundant Controller Failure Detected
Controller SDRAM ECC Multi-bits Error Detected
Controller SDRAM ECC Single-bit Error Detected
Controller SDRAM Parity Error Detected
Controller PCI Bus Parity Error Detected
Controller ALERT: Power Supply Unstable or NVRAM Failed
BBU Absent or Failed! Correct It and Reset Ctlr to Take Effect
Controller BBU Absent or Failed!
Controller BBU Failure Detected!
Controller BBU Thermal Shutdown/Enter Sleep-Mode!
Warning
Memory Not Sufficient to Fully Support Current Config.
Notification
Board1 Cold Temperature Back To Non-Critical LVs(0(C))
+12V Upper Voltage Back within Acceptable Limits(0.0V)
+12V Lower Voltage Back within Acceptable Limits(0.0V)
Memory is Now Sufficient to Fully Support Current Config.
Controller NOTICE: NVRAM Factory Defaults Restored
Controller NOTICE: NVRAM Factory Defaults Restored
Controller NOTICE: NVRAM Factory Defaults Restored
Controller BBU is Charging!
NOTICE: Controller BBU Present!
NOTICE: Controller BBU Back On-Line!
NOTICE: Controller BBU Fully Charged!
Force Controller Write-Through on Trigger Cause