Specifications

SCSI to SATA RAID Subsystem | Administrator’s Manual S.M.A.R.T. Configuration | en 181
Bosch Security Systems F.01U.027.802 | V1 | 2006.11
12.4 Configuration Procedure
Enabling the S.M.A.R.T. Feature
Follow the procedure below to enable S.M.A.R.T. on all drives.
1. First, enable the “Periodic Drive Check Time” function. In \View and Edit Configuration
Parameters\Drive-side Parameters\Periodic Drive Check Time, choose a time interval.
Fig. 12.12 Select Drive Check Time
2. In \View and Edit Configuration Parameters\Drive-side Parameters\Drive Predictable Fail-
ure Mode <SMART>, choose one from “Detect Only,” “Detect, Perpetual Clone” and
“Detect, Clone+Replace.”
Fig. 12.13 Select Drive Failure Mode
Examining Whether Your Drives Support S.M.A.R.T.
To see if your drive supports S.M.A.R.T., follow the steps below:
1. Enable “S.M.A.R.T.” for your drives in the RAID system.
2. In “View and Edit Drives,” choose one drive to test to. Press [ENTER] on the drive; a sub-
menu will appear.
3. Note that a new item “Predictable Failure Test” appears in the sub-menu. If the
S.M.A.R.T.” feature is not properly enabled, this item will not appear in the sub-menu.