Specifications

SCSI to SATA RAID Subsystem | Administrator’s Manual S.M.A.R.T. Configuration | en 177
Bosch Security Systems F.01U.027.802 | V1 | 2006.11
The cloning process will begin with a notification message. Press [ESC] to proceed.
Fig. 12.3 Cloning Status
The cloning process will be indicated by a status bar.
You may quit the status bar by pressing [ESC] to return to the table of the connected drives.
Select the drive indicated as “CLONING” by pressing [ENTER].
Fig. 12.4 Cloning Status
Select “Clone Failing Drive” again to view the current status. You may identify the source drive
and choose to “View Clone Progress,” or “Abort Clone” if you happen to have selected the
wrong drive.
When the process is completed, you will be notified by the following message.
Fig. 12.5 Cloning Drive Completed
Perpetual Clone
The standby spare will clone the source drive, the member drive with predicted errors or any
selected drive, without substituting it. The status of the spare drive will be displayed as “clone
drive” after the cloning process. The source drive will remain a member of the logical drive. If
the source drive fails, the clone drive can readily take its place in the array.
In “View and Edit Drives,” locate the member drive that shows predicted errors. Select “Clone
Failing Drive,” and choose “Perpetual Clone.”
Fig. 12.6 Select Perpetual Clone Drive