Product specifications

LCD Keypad Operation
2-29
2.14.3 Password Validation Timeout
Choose “View and Edit Configuration
Parameters,” “Controller Parameters,”
then press ENT. Select “Password
Validation Timeout,” and press ENT.
Press the up or down arrow keys to
choose to enable a validation timeout from
one to five minutes to Always Check. The
Always Check timeout will invalidate any
configuration change without entering the
correct password.
2.14.4 Controller Unique Identifier
Choose “View and Edit Configuration
Parameters,” “Controller Parameters,"
then press ENT. Press the up or down
arrow keys to select “Ctlr Unique ID-,”
then press ENT. Enter any hex number
between “0” and “FFFFF” and press ENT
to proceed.
Enter a unique ID for any RAID controller in a single or dual-
controller configuration. The unique ID is recognized by the
controller as the following:
1. The unique ID is combined to generate a unique WWN node
name for controllers or RAID systems using Fibre Channel host
ports. The unique node name helps prevent host computers
from mis-addressing the storage system during a controller
failback/failover process.
2. MAC addresses for the controller’s Ethernet port that should be
taken over by a surviving controller in the event of controller
failure.
2.14.5 Controller Date and Time
This submenu is only available for controllers or subsystems that
come with a real-time clock on board.
Time Zone
Choose “View and Edit Configuration
Parameters,” “Controller Parameters,"
then press ENT. Press the up or down
arrow keys to scroll down and select “Set
Controller Date and Time”, then press
ENT.
PasswdValidation
Timeout-5 mins..
Ctlr Unique (Hex)-
ID-
View and Edit
Config Parms
Controller
Parameters ..
Set Controller
Date and Time ..