Product specifications

S.M.A.R.T. Configuration
9-3
The cloning process will be indicated by a status bar.
You may quit the status bar by pressing [ESC] to return to the table
of the connected drives. Select the drive indicated as “CLONING”
by pressing [ENTER].
Figure 9– 4: Cloning Status
Select “Clone Failing Drive” again to view the current status. You
may identify the source drive and choose to “View Clone Progress,”
or “Abort Clone” if you happen to have selected the wrong drive.
When the process is completed, you will be notified by the
following message.
Figure 9 – 5: Cloning Drive Completed
9.1.3 Perpetual Clone:
The standby spare will clone the source drive, the member drive
with predicted errors or any selected drive, without substituting it.
The status of the spare drive will be displayed as “clone drive” after
the cloning process. The source drive will remain a member of the
logical drive. If the source drive fails, the clone drive can readily
take its place in the array.
In “View and Edit Drives,” locate the member drive that shows
predicted errors. Select “Clone Failing Drive,” and choose
“Perpetual Clone.”