Specifications

Page 53
Country Choose the Country where you are located.
Channel This option allows you to select a frequency channel for the wireless
communication.
Default is SmartSelect. It automatically scans and set to the best
channel to use during initial device power up.
To use a specific channel, click the down arrow at the side-bar for
a list of available channels. Just click on the channel number to
select.
* Note: Different country has different channel list. You should first
select the conntry before select the channel.
Tx Rate Allows you to choose the rate of data transmission ranging from
1Mbps to Fully Auto.
The first 8 from top of list, 1Mbps - 54Mbps are for normal standard
802.11a/b/g modulation.
The next 8 starting from MC0-MC8 are for 802.11n for channels with
20MHz bandwidth.
The last 8 starting from MC9-MC15 are for 802.11n for channels with
40MHz bandwidth.
Closed System The access point will not broadcast its WLAN name (ESSID) when
Closed system is enabled. By default Closed system is disabled.
Act as RootAP If device setup as access point (AP), You need to check this
option before AP can communicate with another
device running Repeater or Transparent Client.
This option does not affect standard or normal PC wireless client.
Channel Survey A list of channels that are detected by your access point in the
WLAN. Information such as frequency, channel, MyQuality,
APCount, NeighQuality and Recommendation can be found in the
listing.
The Access Point and Gateway modes support this feature.