Specifications

Page 161
S
S
t
t
e
e
p
p
5
5
:
:
From the Start menu, click Run and type cmd. When the command
prompt window appears, type in the following command:
C:\recovery\TFTP -i 192.168.168.1 PUT image_name.IMG, where C:\ refers
to the local drive and image_name.IMG refers to the firmware filename in
the Recovery folder.
You can monitor the status from the diagnostic light.
While firmware is writing to the flash chip of device, DIAG light will stop
flashing and remain solid light up.
When writing to flash is successfully, it will start to blink slowly (1 flash /sec).
When firmware restoration is complete, reboot the access point and it will
be ready to operate.