Specifications

Page 160
Perform Firmware Recovery
If the system fails to launch properly, the access point will automatically
switch to loader mode and the diagnostic light will remain blinking.
The firmware should then be reloaded.
Access Point State Diagnostic LED ( ) State
Corrupted firmware – access point
automatically switches to loader mode
Blinks very fast
Recovery in progress ON
Successful recovery Blinks very slowly
Before starting, check the status of the diagnostic light to confirm if
firmware failure has occurred.
S
S
t
t
e
e
p
p
1
1
:
:
Stop power supply and disconnect the access point from the network.
S
S
t
t
e
e
p
p
2
2
:
:
Connect the LAN port of the access point to the LAN port of your
computer with an MDI cable.
S
S
t
t
e
e
p
p
3
3
:
:
Power on the access point, and start up your computer. You are
recommended to set your computer’s IP address to 192.168.168.100 and
its network mask to 255.255.255.0.
It is recommended that your computer IP address is set to 192.168.168.100
and the network mask is set to 255.255.255.0
S
S
t
t
e
e
p
p
4
4
:
:
Copy the new firmware to the folder, Recovery, in the local drive of the
computer.