User`s manual

3-2 Chapter 3: Installing the Drivers
XXX
is a 3-digit hex number representing I/O port
base address (Valid value: 200H to 3E0H in
steps of 20H.
MMMM Is a 4-digit hex number representing attribude
mwmory address (Valid value: C800, CC00,
D000, D400, D800, DC00)
/? Help message
Note: The default interrupt line number for the adapter is
5. Notebook computers with built-in sound chips may also
be using this Interrupt value. If you encounter such a
situation, it is best to configure the adapter to a another
Interrupt number such as 10 or 11 to avoid any conflicts.
Before beginning the installation procedure, make a
backup Copy diskette and use the Copy for installation.
Store the original diskette in a safe place.
LANENB.EXE utility
To configure the Compex LinkPort PCMCIA Ethernet
Card properly, you should first run the LANENB.EXE
utility. Enter the following at the DOS prompt:
For example:
LANENB.EXE /int:5 /port:300
The following message will appear:
Socket: 0
IRQ Number: 05
I/O PORT BASE: 0300H
Memory Address: D400H
The Compex LinkPort PCMCIA Ethernet Card is now
configured and you are ready to load the network drivers.