User`s manual

Compex LinkPort PCMCIA Ethernet Card
Chapter 3
Software Installation
Introduction:
Enabler program: Lanenb.EXE
↵LANENB enabler is provided to configure Compex
LinkPort ENET-B in DOS environment.
↵Before any driver (either loaded from Config.sys or
Autoexec.bat or any batch file) can initialize the adapter,
LANENB must be run first to configure it.
↵If PCMCIA Card and Socket Services software is run in
the machine, LANENB.EXE must run immediately after
this (Card and Socket Services) software is loaded, but
before loading the network driver.
↵LANENB.EXE cannot be unloaded. The machine must
reboot and LANENB.EXE re-run to change to a new I/O
Address and Interrupt Number.
To run LANENB.EXE, insert the driver diskette in drive
A:\ and type the following:
A:LANENB [/IRQ=dd] [/IOP=XXX]
A:LANENB [/HLP] or [/?]
A:LANENB [/CHK]
where:
[/IRQ]
Interrupt line keyword of the adapter.
[/IOP]
I/O Base Address keyword of the adapter.
dd
is a one/two digit number representing the
interrupt line (Valid value: 3, 4, 5, 7, 9,
10, 11*, 12, 15). [*Default IRQ]