Specifications

5. Remove the disk drive by pulling the disk drive lever toward you until it is
completely open. Then pull the drive out of the slot.
Replacing a Disk Drive in the Two-Position Disk Drive Bay
The section helps you install non hot-plug drives in the two-position SCSI disk drive
bay.
1. If you have not already done so, shut down the system as described in “Stopping
the System Unit” on page 306.
2. If you have not already done so, unplug the system unit power cable from the
electrical outlet.
3. If you have not already done so, remove the front and right covers as described in
“Removing the Covers” on page 301.
362 Service Guide