Specifications

Replacing a Media Drive in the Optional Media Position
Perform the following steps to remove either the blank cover or the old drive from the
bracket and install the new drive onto the bracket.
1. Remove the three screws from the blank cover bracket.
2. Separate the blank cover or drive from the bracket.
3. Install the new drive into the bracket as shown in the following diagram. To secure
the drive, use the three media media bay screws.
4. Set the SCSI address jumpers at the rear of the drive to SCSI address 0. Refer to
the documentation provided with your drive for details on setting the SCSI address.
5. Look into the media bay and locate the two cables used to attach the drive to the
system unit.
6. Connect the cables from the system to the rear of the drive.
7. Ensure that the locking knobs are pulled to the out position. Install the drive in the
system unit by sliding it into the optional media bay until the locking knobs contact
the frame of the system unit.
8. Push each locking knob until you feel it lock into position.
9. Replace the system unit covers as described in “Replacing Covers” on page 304.
Removing a Disk Drive from the Two-Position Disk Drive Bay
The section helps you remove non-hot-plug drives from the two-position SCSI disk drive
bay.
1. If you have not already done so, shut down the system as described in “Stopping
the System Unit” on page 306.
2. If you have not already done so, unplug the system unit power cable from the
electrical outlet.
3. If you have not already done so, remove the front cover as described in “Removing
the Covers” on page 301.
360 Service Guide