Specifications

Replacing Six-Position SCSI (SES) or SSA Disk Drive Bays
1. If you are installing a second disk drive bay, and an adapter to connect the disk
drive bay to the system, install the adapter first. Refer to “Replacing Adapter Cards”
on page 322.
2. Locate the new disk drive bay cage and connect the power cables to the top rear of
the backplane. Then connect the signal cables to the backplane.
SCSI (SES) Drive Bay Cables
2
3
4
5
1
1I
2
C Connector 4 Power Connector
2 SCSI Connector 5 SCSI Connector
3 Power Connector
Chapter 9. Removal and Replacement Procedures
351