Specifications

5. Connect the SCSI cable connectors to the backplane. See “SCSI and SSA Cabling
Configurations” on page 355 for cable routing.
6. Install the screws to hold the two-position cage in place.
7. Replace the system unit covers as described in “Replacing Covers” on page 304.
8. Turn on the power.
Removing Six-Position SCSI (SES) or SSA Disk Drive Bays
Note: SSA bays require a carrier in all six slots of each 6-pack assembly. Either an
SSA drive in a carrier or a blank carrier must be in each SSA drive position. To
add an SSA drive, you must first remove the blank carrier from the slot.
1. If you have not already done so, shut down the system as described in “Stopping
the System Unit” on page 306.
2. If you have not already done so, unplug the system unit power cable from the
electrical outlet.
Chapter 9. Removal and Replacement Procedures 347