Specifications

Table 7. Service Processor Error Codes (continued)
Error Code Description Action/ Possible Failing FRU
4B2F 300D Processor system and error code
generation/logging detected 512MB
(stacked) DIMM fault
Memory DIMM, Location: P1-M1.n or
P1-M2.n or P1-C1-Mn
4B2F 300E Processor system and error code
generation/logging detected 512MB
(unstacked) DIMM fault
Memory DIMM, Location: P1-M1.n or
P1-M2.n or P1-C1-Mn
4B2F 301F Processor system and error code
generation/logging detected 128MB
DIMM fault
Memory DIMM, Location: P1-M1.n or
P1-M2.n or P1-C1-Mn
4B2F 303A Processor system and error code
generation/logging detected 1GB
DIMM fault
Memory DIMM, Location: P1-M1.n or
P1-M2.n or P1-C1-Mn
System Firmware Update Messages
Table 8. System Firmware Update Messages
Error Code Description Action/ Possible Failing FRU
A1FD 0000 Service processor flash recovery
mode entered
Attention message
A1FD 0001 Service processor flash recovery Insert Diskette #1
A1FD 0002 Service processor flash recovery Insert Diskette #2
A1FD 0003 Service processor flash recovery Insert Diskette #3
A1FD 0004 Service processor flash recovery Insert Diskette #4
Common Firmware Error Codes
Attention: Follow the procedure defined in the “Checkpoint and Error Code Index” on
page 100. If you replace FRUs or perform an action and the problem is still not
corrected, go to “MAP 1540: Minimum Configuration” on page 52 unless otherwise
indicated in the tables.
If you replace FRUs or perform an action and the problem is corrected, go to ″MAP
410: Repair Checkout″ in
Diagnostic Information for Multiple Bus Systems .
Note: Do not shut down the system if the FRU was replaced by hot swap.
Table 9. Common Firmware Error Codes
Error Code Description Action/ Possible Failing FRU
B006 1403 Missing service processor resource 1. Update system firmware
2. System board, Location: P1
Chapter 5. Error Code to FRU Index
233