Specifications

Table 7. Service Processor Error Codes (continued)
Error Code Description Action/ Possible Failing FRU
406F 00A1 Error code generation/logging
detected system firmware fault
1. Check for AIX updates
2. Check for system firmware
updates
406F 00A2 Error code generation/logging
detected service processor firmware
(PRD) fault
Update system firmware
406F 00A3 Error code generation/logging
detected memory plugging fault
Go to “MAP 1540: Minimum
Configuration” on page 52.
406F 00A4 Error code generation/logging
detected application caused fault
Application software
406F 00A5 Error code generation/logging
detected invalid system configuration
Verify that system components are
supported and properly installed
406F 00A6 Error code generation/logging
detected no usable memory
1. Ensure that memory is properly
installed
2. If more than one DIMM is called
out, go to the service processor
Memory
Configuration/Deconfiguration
Menu to verify memory DIMMs
state. See ″Memory
Configuration/Deconfiguration
Menu″ on page 260 for more
information.
3. Go to “MAP 1540: Minimum
Configuration” on page 52
4. If the problem is not fixed, call
service support.
406F 00A7 Error code generation/logging
detected hardware problem
Go to “MAP 1540: Minimum
Configuration” on page 52.
406F 00B0 Error code generation/logging
detected bus controller lock-unlock
failure
System board, Location: P1
406F 00B1 Error code generation/logging
detected bus controller failure
System board, Location: P1
406F 00B7 Error code generation/logging
detected insufficient hardware
resources to continue IPL
This error code appears after the
initial testing by the service processor
firmware on the processors and
memory completed successfully, but
a problem occurred when the
firmware tried to communicate
outside the processor and memory
complex. Suspect a problem with the
backplane, location: P1.
406F 0100 Error code generation/logging
detected memory riser card fault
Memory riser card Location: P1-M2
174 Service Guide