Specifications

Table 7. Service Processor Error Codes (continued)
Error Code Description Action/ Possible Failing FRU
406D 032D Attention handler detected memory
DIMM fault
Memory DIMM Location: P1-C1-M3
x2
406D 0331 Attention handler detected memory
DIMM fault
Memory DIMM Location: P1-C1-M5
406D 0332 Attention handler detected memory
DIMM fault
Memory DIMM Location: P1-C1-M4
406D 033D Attention handler detected memory
DIMM fault
Memory DIMM Location: P1-C1-M4
x2
406D 03FF Attention handler detected memory
failure on processor card that cannot
be automatically isolated.
Go to “MAP 1540: Minimum
Configuration” on page 52, and run
minimum configuration for further
isolation.
406D 3101 Attention handler detected RIO port 0
fault
1. RIO port 0, Location: P1-C1
2. System board, Location: P1
406D 3281 Attention handler detected RIO port 0
fault
1. RIO port 0, Location: P1-C1
2. System board, Location: P1
406D 3284 Attention handler detected PCI
controller PHB0 fault
Replace the system board. Location:
P1 (See note 3 on page 37.)
406D 3285 Attention handler detected PCI
controller PHB1 fault
Replace the system board. Location:
P1 (See note 3 on page 37.)
406D 3286 Attention handler detected PCI
controller PHB2 fault
Replace the system board. Location:
P1 (See note 3 on page 37.)
406E 0001 Scan control routines detected
system board fault
Replace the system board. Location:
P1 (See note 3 on page 37.)
406E 0003 Scan control routines detected
processor fault
All processors, Location: P1-C1
406E 0009 Scan control routines detected
memory fault
Go to “MAP 1540: Minimum
Configuration” on page 52.
406E 00A0 Scan control routines detected
service processor firmware fault
Update system firmware
406E 00A1 Scan control routines detected
system firmware fault
1. Check for AIX updates
2. Check for system firmware
updates
406E 00A2 Scan control routines detected
service processor firmware (PRD)
fault
Update system firmware
406E 00A3 Scan control routines detected
memory plugging fault
Go to “MAP 1540: Minimum
Configuration” on page 52.
406E 00A4 Scan control routines detected
application caused fault
Application software
406E 00A5 Scan control routines detected invalid
system configuration
Verify that system components are
supported and properly installed
Chapter 5. Error Code to FRU Index
169