Specifications

Table 7. Service Processor Error Codes (continued)
Error Code Description Action/ Possible Failing FRU
406C 00A1 IPL MOPs detected system firmware
fault
1. Check for AIX updates
2. Check for system firmware
updates
406C 00A2 IPL MOPs detected service
processor firmware (PRD) fault
Update system firmware
406C 00A3 IPL MOPs detected memory plugging
fault
Go to “MAP 1540: Minimum
Configuration” on page 52.
406C 00A4 IPL MOPs detected application
caused fault
Application software
406C 00A5 IPL MOPs detected invalid system
configuration
Verify that system components are
supported and properly installed
406C 00A6 IPL MOPs detected no usable
memory
1. Ensure that memory is properly
installed
2. If more than one DIMM is called
out, go to the service processor
Memory
Configuration/Deconfiguration
Menu to verify memory DIMMs
state. See ″Memory
Configuration/Deconfiguration
Menu″ on page 260 for more
information.
3. Go to “MAP 1540: Minimum
Configuration” on page 52
4. If the problem is not fixed, call
service support.
406C 00A7 IPL MOPs detected hardware
problem
Go to “MAP 1540: Minimum
Configuration” on page 52.
406C 00B0 IPL MOPs detected bus controller
lock-unlock failure
System board, Location: P1
406C 00B1 IPL MOPs detected bus controller
failure
System board, Location: P1
406C 00B7 IPL MOPS detected insufficient
hardware resources to continue IPL
This error code appears after the
initial testing by the service processor
firmware on the processors and
memory completed successfully, but
a problem occurred when the
firmware tried to communicate
outside the processor and memory
complex. Suspect a problem with the
backplane, location: P1.
406C 0100 IPL MOPs detected memory riser
card fault
Memory riser card Location: P1-M2
406C 0101 IPL MOPs detected memory DIMM
fault
Memory DIMM Location: P1-M2.15
Chapter 5. Error Code to FRU Index
161