Specifications

Table 7. Service Processor Error Codes (continued)
Error Code Description Action/ Possible Failing FRU
406B 00A6 Wire tests detected no usable
memory
1. Ensure that memory is properly
installed
2. If more than one DIMM is called
out, go to the service processor
Memory
Configuration/Deconfiguration
Menu to verify memory DIMMs
state. See ″Memory
Configuration/Deconfiguration
Menu″ on page 260 for more
information.
3. Go to “MAP 1540: Minimum
Configuration” on page 52
4. If the problem is not fixed, call
service support.
406B 00A7 Wire tests detected hardware
problem
Go to “MAP 1540: Minimum
Configuration” on page 52.
406B 00B0 Wire tests detected bus controller
lock-unlock failure
System board, Location: P1
406B 00B1 Wire tests diagnostics detected bus
controller failure
System board, Location: P1
406B 00B7 Wire test detected insufficient
hardware resources to continue IPL
This error code appears after the
initial testing by the service processor
firmware on the processors and
memory completed successfully, but
a problem occurred when the
firmware tried to communicate
outside the processor and memory
complex. Suspect a problem with the
backplane, location: P1.
406B 0100 Wire tests detected memory riser
card fault
Memory riser card Location: P1-M2
406B 0101 Wire tests detected memory DIMM
fault
Memory DIMM Location: P1-M2.15
406B 0102 Wire tests detected memory DIMM
fault
Memory DIMM Location: P1-M2.1
406B 0103 Wire tests detected memory DIMM
fault
Memory DIMM Location: P1-M2.16
406B 0104 Wire tests detected memory DIMM
fault
Memory DIMM Location: P1-M2.2
406B 010D Wire tests detected memory DIMM
fault
Memory DIMM Location: P1-M2.1 x4
406B 0111 Wire tests detected memory DIMM
fault
Memory DIMM Location: P1-M2.13
406B 0112 Wire tests detected memory DIMM
fault
Memory DIMM Location: P1-M2.3
Chapter 5. Error Code to FRU Index
157