Specifications

Table 7. Service Processor Error Codes (continued)
Error Code Description Action/ Possible Failing FRU
4069 3281 Memory tests detected RIO port 0
fault
1. RIO port 0, Location: P1-C1
2. System board, Location: P1
4069 3284 Memory tests detected PCI controller
PHB0 fault
Replace the system board. Location:
P1 (See note 3 on page 37.)
4069 3285 Memory tests detected PCI controller
PHB1 fault
Replace the system board. Location:
P1 (See note 3 on page 37.)
4069 3286 Memory tests detected PCI controller
PHB2 fault
Replace the system board. Location:
P1 (See note 3 on page 37.)
406A 0001 Self tests detected system board fault Replace the system board. Location:
P1 (See note 3 on page 37.)
406A 0003 Self tests detected processor fault All processors, Location: P1-C1
406A 0009 Self tests detected memory fault Go to “MAP 1540: Minimum
Configuration” on page 52.
406A 00A0 Self tests detected service processor
firmware fault
Update system firmware
406A 00A1 Self tests detected system firmware
fault
1. Check for AIX updates
2. Check for system firmware
updates
406A 00A2 Self tests detected service processor
firmware (PRD) fault
Update system firmware
406A 00A3 Self tests detected memory plugging
fault
Go to “MAP 1540: Minimum
Configuration” on page 52.
406A 00A4 Self tests detected application
caused fault
Application software
406A 00A5 Self tests detected invalid system
configuration
Verify that system components are
supported and properly installed
406A 00A6 Self tests detected no usable
memory
1. Ensure that memory is properly
installed
2. If more than one DIMM is called
out, go to the service processor
Memory
Configuration/Deconfiguration
Menu to verify memory DIMMs
state. See ″Memory
Configuration/Deconfiguration
Menu″ on page 260 for more
information.
3. Go to “MAP 1540: Minimum
Configuration” on page 52
4. If the problem is not fixed, call
service support.
406A 00A7 Self tests detected hardware problem Go to “MAP 1540: Minimum
Configuration” on page 52.
406A 00B0 Self tests detected bus controller
lock-unlock failure
System board, Location: P1
152 Service Guide