Specifications
Table 6. Firmware Error Codes (continued)
Error Code Description Action/ Possible Failing FRU
25A8 0xxx NVRAM problems Errors reported against NVRAM can
be caused by low battery voltage and
(more rarely) power outages that
occur during normal system usage.
With the exception of the 25A80000
error, these errors are warnings that
the NVRAM data content had to be
reestablished and do not require any
FRU replacement unless the error is
persistent. When one of these errors
occurs, any system customization (for
example, boot device list) information
has been lost; the system may need
to be reconfigured.
If the error is persistent, replace
system board. (See note 3 on
page 37.) Location: P1
25A8 0000 Initialization failed, device test failed Refer to Action under error code
25A80xxx.
25A8 0001 Init-NVRAM invoked, all of NVRAM
initialized
Refer to Action under error code
25A80xxx.
25A8 0002 Init-NVRAM invoked, some data
partitions may have been preserved.
Refer to Action under error code
25A80xxx.
25A8 0011 Data corruption detected, all of
NVRAM initialized
Refer to Action under error code
25A80xxx.
25A8 0012 Data corruption detected, some data
partitions may have been preserved.
Refer to Action under error code
25A80xxx.
25A8 0021 Data corruption detected during error
log entry. All of NVRAM initialized
Refer to Action under error code
25A80xxx.
25A8 0022 Data corruption detected during error
log entry. Some data partitions may
have been preserved.
Refer to Action under error code
25A80xxx.
25A8 0100 NVRAM data validation check failed. Turn off, turn on system unit and
retry the operation before replacing
any system component.
Refer to Action under error code
25A80xxx.
25A8 0201 Unable to expand target partition -
Ssving configuration variable.
Refer to Action under error code
25A80xxx.
25A8 0202 Unable to expand target partition -
writing error log entry.
Refer to Action under error code
25A80xxx.
25A8 0203 Unable to expand target partition -
writing VPD data.
Refer to Action under error code
25A80xxx.
25A8 0210 Setenv/$Setenv parameter error -
name contains a null character.
Refer to Action under error code
25A80xxx.
124 Service Guide