Specifications

Table 2. Firmware Checkpoints (continued)
Checkpoint Description Action/ Possible Failing FRU
E604 SSA PCI adapter BIST and
subsequent POSTs have completed
successfully.
If a location code is associated with
the checkpoint, replace the adapter
identified by the location code. See
“Determining Location Code” on
page 99.
E605 SSA PCI adapter BIST has
completed successfully but the
subsequent POSTs have failed.
If a location code is associated with
the checkpoint, replace the adapter
identified by the location code. See
“Determining Location Code” on
page 99.
E60E SSA PCI adapter open firmware
about to exit (no stack corruption).
If a location code is associated with
the checkpoint, replace the adapter
identified by the location code. See
“Determining Location Code” on
page 99.
E60F SSA PCI adapter open firmware
has run unsuccessfully.
If a location code is associated with
the checkpoint, replace the adapter
identified by the location code. See
“Determining Location Code” on
page 99.
E6FF SSA PCI adapter open firmware
about to exit (with stack corruption).
If a location code is associated with
the checkpoint, replace the adapter
identified by the location code. See
“Determining Location Code” on
page 99.
E700 Create system firmware VPD. Replace the system board,
Location: P1. See the note on page
78.
E701 Create memory VPD. Replace the memory. See the note
on page 78.
E702 Create processor card VPD. Go to “MAP 1540: Minimum
Configuration” on page 52.
E703 Create operator panel VPD. Replace the operator panel,
Location: L1. See “Operator Panel
Replacement” on page 99.
E704 Create CEC VPD. See the note on page 78.
E705 Create clock card VPD. See the note on page 78.
E706 Create RIO extender card VPD. Replace the system planar,
Location: P1. See the note on page
78.
E707 Create system VPD. Replace the system planar,
Location: P1. See the note on page
78.
E708 Create RIO to PCI adapter VPD. Replace the system planar,
Location: P1. See the note on page
78.
94 Service Guide