Specifications

Table 2. Firmware Checkpoints (continued)
Checkpoint Description Action/ Possible Failing FRU
E105 Transfer control to operating
system (normal boot).
See “Boot Problems and Concerns”
on page 96.
E10A Load RTAS device tree See the note on page 78.
E10B Set RTAS device properties See the note on page 78.
E122 RTAS sensor setup complete See the note on page 78.
E130 Build device tree See the note on page 78.
E134 Create memory node See the note on page 78.
E137 Create openprom node See the note on page 78.
E138 Create options node See the note on page 78.
E139 Create node aliases and system
aliases
See the note on page 78.
E13A Create packages node See the note on page 78.
E140 Operating system load See the note on page 78.
E149 Create boot mgr node See the note on page 78.
E14C Create terminal-emulator node See the note on page 78.
E14D Loading boot image See “Boot Problems and Concerns”
on page 96.
E14F NVRAM initialization See the note on page 78.
E150 Create host (primary) PCI controller
node
1. If a location code is associated
with the checkpoint, replace the
adapter identified by the
location code. See “Determining
Location Code” on page 99.
If a network adapter is
replaced, see “Replacing the
Network Adapter” on page 99.
2. Replace the system board. See
note 3 on page 37.
E151 Probing primary PCI bus Go to “Step 1540-25” on page 68.
E152 Probing for adapter FCODE;
evaluate if present
Follow the repair action listed for
checkpoint E151.
E153 End probe/evaluate of adapter
FCODE
Follow the repair action listed for
checkpoint E151.
E154 Create PCI bridge node Follow the repair action listed for
checkpoint E151.
E155 Probing PCI bridge secondary bus Follow the repair action listed for
checkpoint E151.
E156 Create PCI Ethernet node Follow the repair action listed for
checkpoint E151.
E15A Create 64-bit host (primary) PCI
controller node
See the note on page 85.
86 Service Guide