Installation guide
Verifying the Installation
1. If the 7133 is going to be used as an SSA RAID subsystem, go to the user or
service information for your SSA adapter for information about how to configure
RAID arrays. When you have configured the RAID arrays, return here and go to
step 2.
If the 7133 is not going to be used as an SSA RAID subsystem, go to step 2.
2. Use the SSA Remote Systems Management configurator to check whether the SSA
loops that you have configured on the adapter are complete and correct. (For
information about the SSA Remote Systems Management configurator, see the user
or service information for your SSA adapter.)
If the loops are correct, go to step 3.
If the loops are not correct, go to the START MAP in the service information for your
SSA adapter, if you are qualified technically to do so. Otherwise, call your service
representative.
3. Run diagnostics to the:
v Adapter
v Disk drive modules
v Enclosure (7133)
For information about diagnostics, see the “Additional Information” appendix for your
using system in the 7133 Models D40 and T40 Serial Disk Systems: Service Guide
if you are qualified technically to do so. Otherwise, call your service representative.
4. Close and lock the back cover of the 7133.
5. If the 7133 has the Advanced SSA Optical Extender (Pair) feature, go to step 6.
Otherwise, go to step 8 on page 64.
6. Refer to Figure 36.
7. Ensure that the Power light 2 and the Receive light 1 of every optical extender
are on.
If all the lights are on, go to step 8 on page 64.
Part Number nnnnnnn
Class 1 Laser Product
FCC Class A - See Manual
1
1
2
2
Part Number nnnnnnn
Class 1 Laser Product
FCC Class A - See Manual
Figure 36. Checking the Lights on an Optical Extender
Appendix D. Additional Information for PC Servers 63
|
|
|
|
|
|
|
|
|
|