Installation guide

1. When the fibre optic cables were installed, they were marked with some type of
identification to enable you to recognize opposite ends of the same cable.
Attach identification labels to the fibre optic cables.
2. Find the SSA adapter in the using system.
3. Refer to Figure 33.
1 SSA Loop B Port 2 4 SSA Loop A Port 1
2 SSA Loop B Port 1 5 Optical Extender
3 SSA Loop A Port 2
4. Using the subsystem configuration information and the information from step 4 on
page 9, plug optical the extenders 5 into the appropriate connectors on the SSA
adapter. Ensure that you tighten the screws on the connector of each optical
extender.
Note: To prevent damage to the SSA connector screws, ensure that you use the
special screwdriver (SSA tool, part 32H7059) to tighten them. The
screwdriver is supplied with the 7133.
5. If you are connecting the fibre optic cables for single-mode operations, go to
Connecting Fibre Optic Cables for Single-Mode Operationson page 60.
If you are connecting the fibre optic cables for multi-mode operations, go to
Connecting Fibre Optic Cables for Multi-Mode Operationson page 61.
4
3
2
1
5
Figure 33. A Typical SSA Adapter with Optical Extender
Appendix D. Additional Information for PC Servers 59
|
|
|
|
|