Installation guide

Connecting to the Using System

If the SSA adapter has not yet been installed into the using system, install it now (see

the user or maintenance information for your using system and for the adapter).

Connecting SSA Cables to the SSA Adapter

Note: For details of SSA cables, see “SSA Cables” on page 38.

1. Attach identification labels to the SSA cables.

2. Find the SSA adapter in the using system.

3. Refer to Figure 32.

1 SSA Loop B Port 2 3 SSA Loop A Port 2

2 SSA Loop B Port 1 4 SSA Loop A Port 1

4. Using your plan for the subsystem configuration and the information from step 4 on

page 9, plug SSA cables into the appropriate connectors on the SSA attachment.

Ensure that you tighten the screws on the cable connectors.

Note: To prevent damage to the SSA connector screws, ensure that you use the

special screwdriver (SSA tool, part 32H7059) to tighten them. The

screwdriver is supplied with the 7133.

5. Ensure that all the SSA cables are correctly connected.

Figure 32. A Typical SSA Adapter

56 7133 Model T40 Installation Guide