Installation guide

If you cannot fasten the bayonet connector, disconnect the cable, and try
again.
3. Ensure that all fibre optic cables are correctly connected to the adapter.
4. Attention: Excessive movement at connections in a fibre optic link might cause link
errors.
Ensure that the fibre optic cables are held tightly by cable ties to prevent strain and
movement at the optical extenders.
5. If not already done, put the wrap cable and adapter assembly into its plastic bag,
and put the bag into a safe place that is as close to the optical extender as
possible.
6. If you are also connecting SSA cables, but have not done so yet, go to “Connecting
SSA Cables to the SSA Adapter” on page 45. Otherwise, go to “Checking Whether a
Remote-Power-On-Control Unit is Present” on page 19.
50 7133 Model T40 Installation Guide
|
|
|
|
|