Installation guide

1. When the fibre optic cables were installed, they were marked with some type of
identification to enable you to recognize opposite ends of the same cable.
Attach identification labels to the fibre optic cables (see the Site and Hardware
Planning Information manual for details).
2. Find the SSA adapter in the using system.
3. Refer to Figure 28.
1 Connector B2 4 Connector A1
2 Connector B1 5 Type-number label
3 Connector A2 6 Optical Extender
4. Using the subsystem configuration information and the information from step 4 on
page 9, plug the optical extenders 6 into the connectors on the SSA adapter.
Ensure that you tighten the screws on the connector of each optical extender.
6
5
4
3
2
1
Figure 28. Connecting an Optical Extender to an SSA Adapter
48 7133 Model T40 Installation Guide
|
|
|
|