Installation guide

4. Using the subsystem configuration information and the information from step 4 on
page 9 , plug an SSA cable into the appropriate connector on the SSA adapter.
Ensure that you tighten the screws on the cable connectors.
Note: To prevent damage to the SSA connector screws, ensure that you use the
special screwdriver (SSA tool, part 32H7059) to tighten them. The
screwdriver is supplied with the 7133.
5. Ensure that all the SSA cables are correctly connected.
6. If you are also connecting fibre optic cables, but have not done so yet, go to
“Installing and Connecting Advanced SSA Optical Extenders to the SSA Adapter” on
page 47. Otherwise, go to “Checking Whether a Remote-Power-On-Control Unit is
Present” on page 19.
46 7133 Model T40 Installation Guide