Installation guide

a. Remove the jumpers, and install them into the required positions (see figures 25
and 26).
b. Reinstall the bypass cards, and tighten their thumbscrews.
c. If you removed any SSA cables or optical extenders at the start of this
procedure, reinstall them.
Note: When you reinstall the external SSA cables, or optical extenders, ensure
that you use the special screwdriver (SSA tool, part 32H7059) to tighten
the SSA connector screws.
d. Return to the installation instructions.
Appendix B. Changing the Jumpers on a Bypass Card 41
|
|
|
|
|
|