Installation guide

Appendix B. Changing the Jumpers on a Bypass Card
This appendix describes how to change the mode of a bypass card.
Attention: The bypass cards are electrostatic-discharge (ESD) sensitive. Use the tools
and procedures defined by your organization to protect such parts.
1. If external SSA cables or optical extenders are already connected to the 7133, note
their positions, then disconnect them. To prevent damage to the SSA connector
screws, ensure that you use the special screwdriver (SSA tool, part 32H7059) to
unscrew them. The screwdriver is supplied with the 7133.
2. Refer to Figure 24.
4
1
2
3
Figure 24. Removing Bypass Cards
39
|
|
|
|
|