Installation guide

If the error ID is HOT, the internal dc power switches on automatically after
the temperature has decreased and has remained more than 5°C below the
critical temperature for 15 minutes.
a. Find the displayed error ID in Table 1 on page 25, and note its related SRN.
b. Go to “Service Request Numbers” in the 7133 Models D40 and T40 Serial Disk
Systems: Service Guide if you are qualified technically to do so. Otherwise, call
your service representative.
19. When the lights and ID display are correct, go to Verifying the Installation in the
“Additional Information” appendix (in this book) for your using system.
26 7133 Model T40 Installation Guide