Installation guide
14. If the 7133 Power light comes on, go to step 15.
If the light still does not come on, go to “MAP 2010: 7133 – START” in the 7133
Models D40 and T40 Serial Disk Systems: Service Guide if you are qualified
technically to do so. Otherwise, call your service representative.
15. Using the ID push buttons 6, the service functions (see the 7133 Models D40
and T40 Serial Disk Systems: Service Guide), or the command line functions (see
the user or maintenance information for your SSA attachment), set the four-digit
enclosure ID. You can use any combination of the following characters to make the
enclosure ID:
A through Z
0 through 9
? ! & . blank
Ensure that this four-digit enclosure ID is different from all other enclosure IDs that
are used in the SSA subsystem.
The enclosure ID that you set is displayed on the ID display 4. The using system
uses this ID to configure the 7133 into the SSA subsystem. Errors that are
detected in the 7133 are logged against this enclosure ID.
16. The using system automatically configures the SSA loop when power is supplied to
the disk drive modules. This configuration might take a few minutes to complete.
When the disk drive status lights 5 for all the installed disk drive modules are on
continuously (not flashing), configuration is complete.
Note: These 16 green status lights are related to the disk drive modules that are
installed in the 7133. The upper row of eight lights represents, from left to
right, the front disk drive modules 1 through 8. The lower row represents,
from right to left, the back disk drive modules 9 through 16. If a dummy disk
drive module is present in a particular slot, the related disk drive status light
does not come on.
When the configuration is complete, observe the 7133, and check whether the
lights and the ID display are as described here (refer to Figure 14 on page 23):
7133 Power light 1:On
7133 Check light 2:Off
Disk drive status light for each installed disk drive module5:On
ID display 4: Continuously showing the ID of the 7133
If the lights and ID display are as described here, go to Verifying the Installation in
the “Additional Information” appendix (in this book) for your using system.
If the lights and ID display are not as described here, go to step 17.
17. If the 7133 Check light is on, observe the ID display 4.
v If the ID display is continuously showing the ID of the 7133, go to “MAP 2010:
7133 – START” in the 7133 Models D40 and T40 Serial Disk Systems: Service
Guide if you are qualified technically to do so. Otherwise, call your service
representative.
24 7133 Model T40 Installation Guide