Installation guide

Connecting the 7133 Model T40 to the Power Source

1. Refer to Figure 12.

2. Ensure that the two short cables 3 are plugged into the power supply

assemblies.

3. The 7133 Model T40 is supplied with two power cables and plugs that are suitable

for your country. Plug the power cables into the sockets 1 and 2.

4. Ensure that both power supply assemblies are switched on; that is, the

PWR/FAULT RESET switch lever 4 of each power supply assembly is pointing

leftward. To switch on a power supply assembly, push the switch leftward.

Note: On early power supply assemblies, pull the switch outward, then push it

leftward.

5. If the 7133 has a remote-power-on control unit, go to step 6 on page 22.

Otherwise, go to step 8 on page 22.

Figure 12. Plugging In the Power Cables

Installing and Testing the 7133 Model T40 21