Installation guide

1. When the fibre optic cables were installed, they were marked with some type of
identification to enable you to recognize opposite ends of the same cable.
Attach identification labels to the fibre optic cables (see the Site and Hardware
Planning Information manual, or equivalent, for details).
2. Refer to Figure 7.
3. Using the subsystem configuration information and the information from step 4 on
page 9, plug the optical extenders into the appropriate connectors 1. Ensure that
you tighten the screws on the connector of each optical extender.
Note: To prevent damage to the SSA connector screws, ensure that you use the
special screwdriver (SSA tool, part 32H7059) to tighten them. The
screwdriver is supplied with the 7133.
1
1
1
Figure 7. Connecting the Optical Extenders to a 7133 Model T40
Installing and Testing the 7133 Model T40 15
|
|
|