Installation guide

Connecting SSA Cables to the 7133 Model T40

1. Attach identification labels to the SSA cables (see the Site and Hardware Planning

Information manual, or equivalent, for details).

2. Refer to Figure 6.

3. Using the subsystem configuration information and the information from step 4 on

page 9, plug SSA cables into the appropriate connectors 1 on the 7133. Ensure

that you tighten the screws on the cable connectors.

Note: To prevent damage to the SSA connector screws, ensure that you use the

special screwdriver (SSA tool, part 32H7059) to tighten them. The

screwdriver is supplied with the 7133.

4. Ensure that all the SSA cables are correctly connected.

5. If you are also connecting the 7133 to fibre optic cables, but have not done so yet,

go to “Installing and Connecting Advanced SSA Optical Extenders to the 7133

Model T40” on page 14. Otherwise, go to Connecting to the Using System in the

“Additional Information” appendix (in this book) for your using system.

Figure 6. SSA Connectors at the Back of the 7133 Model T40

12 7133 Model T40 Installation Guide