User's Manual

VLAN Management
Vlan management lets you control and limit only clients connection of same tag vlan ID group be
open AP device web page.
* Note:-
Vlan Management works only in tag vlan pass-through mode. i.e. Vlan Switch is disabled.
When Vlan Switch is enabled or configured, Vlan Management function stops operation.
Example:
Assuming there are 2 VLAN ID groups, 2001 and 2002 setup in AP device.
One entry in Vlan Management has Vlan ID 2001 with masquerade IP address 192.168.168.20
Another entry in Vlan Management has Vlan ID 2002 with masquerade IP address 192.168.168.10
You can only select one of the 2 entries to be the active Vlan ID and IP address.
If Vlan ID 2001 group is selected, then only computers in that Vlan ID group can open the AP
device web page using the IP address, http://192.168.168.20
To change to other ID group say, Vlan ID 2002, mark the radio button under Management IP, then
click Apply and Saved.
If there is no entry in Vlan Management, there is no restriction. All computers can open the AP
device web page by the default IP address setup in Basic Network page.