User's Manual

Country Code
Different countries have different power levels and also frequency selections. To ensure
device operation follows regulatory compliance rules, the operator should make sure that
correct country code where device will be used, is selected. The channel list, output power
limits, IEEE 802.11 and Channel Spectrum Width modes will be tuned according to the
regulations of the selected country. Station setting must match AP country code setting.
No Country Set:
Option when checked, only the frequency range are available.
11n 2.4GHz is 2412-2462MHz, 11n 5GHz is 5180-5240MHz and 5745-5825MHz.
Wireless Profile:
NA is 11n 5GHz band and represents a mixed of 802.11n and 802.11a mode.
NG
is 11n 2.4GHz band and represents a mixed of 802.11n, 802.11g and 802.11b mode.
**
Station setting must match AP Wireless Profile setting.
Channel Spectrum Width
20M represents the data transmitted at a bandwidth of 20MHz. 20/40MHz represents the
data transmitted at either 20MHz or 40MHz. In very noisy environment it automatically
fall back to 20MHz to be more resilient to the interference. In situation when auto fall
back did not happened, manually changing channel spectrum width to 20MHz will to
help reduce interference on the link and improve performance.
* Note: 40MHz bandwidth is non-standard for 802.11n/g mode operation. If you
experience unstable performance change Channel Spectrum Width to 20M.
** Station setting must match AP Channel Spectrum Width setting.
Maximum : checking this box will result in maximum Tx output power overriding regulation.
Obey Regulatory Power : checking this box will obey Tx output regulatory power by country.
Channel Scan List
Not Channel scan set