User's Manual

Chapter 2 Getting Started

This chapter outlines the basic requirement for any installation and

configuration on the USB adapter.

2.1 Overall Setup Procedures

Here are some of the basic steps to guide you along:

1. Hardware Installation

Please refer to Section 3.1 “Hardware Installation”.

2. Drivers and Utility Installation

Please refer to Section 3.2 “Drivers and Utility Installation”.

3. Configure your USB adapter

Please refer to Chapter 5 “The Atheros Utility Configuration”.

For Windows XP user, you can use the built-in utility – Wireless Zero

Configuration to configure your USB adapter. Please refer to

Appendix III “Windows XP Wireless Zero Configuration Utility”.

NOTE

It is advisable to activate EITHER one of the utilities: the Wireless

Zero Configuration Utility OR the Atheros Utility.