User's Manual

The module is only limited to installation in mobile applications. The antenna must be
installed such that 20 cm is maintained between the antenna and users，and the
transmitter module may not be co-located with any other transmit or antenna. The
module shall be only used with the integral antenna(s) that has been originally tested
and certified with this module.
As long as 3 conditions above are met，further transmitter test will not be required.
However，the OEM integrator is still responsible for testing their end-product for any
additional compliance requirement with this module installed (for example，digital
device emission，PC peripheral requirements，etc.)
End product labeling
This transmitter module is authorization only for use in device where the antenna may
be installed such that 20 cm may be maintained between the antenna and users. The
final end product must be labeled in a visible area with the following：“Contains
Transmitter Module FCC ID: TK4-WLM54AG or Contains FCC ID: TK4-WLM54AG”
Information that must be placed in the end user manual：
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user’s manual of the end
product which integrates this module. The end user manual shall include all required
regulatory information/warning as show in this manual.