User's Manual

Compliance Information
FCC Compliance Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation. This device must accept any
interference received, including interference that may cause undesired
operation. Product that is a radio transmitter is labeled with FCC ID.
FCC Caution:
(1) Exposure to Radio Frequency Radiation. This equipment must be installed
and operated in accordance with provided instructions and the antenna(s)
used for this transmitter must be installed to provide a separation distance
which shown as following table from all persons and must not be collocated
or operating in conjunction with any other antenna or transmitter.
Antenna Used
Frequency
Range (MHz)
Maximum
Conducted Power
(dBm)
Limit of Power
Density
S(W/m
2
)
Safety
Distance
r (cm)
Dipole Antenna
(C0053-ANG0003)
2dBi
5470 ~ 5850 26.51 10 7.5
Panel Antenna
(MJE2-5N17)
17dBi
5725 ~ 5850 26.51 10 42.3
Panel Antenna
(MME2-5N19)
19dBi
5725 ~ 5850 26.51 10 51.9
Dual Polarized Wide-
Band Antenna (58DP)
26dBi
5725 ~ 5850 26.51 10 119.1
End-users and installers must be provided with antenna installation instructions
and transmitter operating conditions for satisfying RF exposure compliance.
Note: this device is used exclusively for fixed, point to point operation, and it
will be installed professionally. According to the above antenna list, if dipole
antenna (C0053-ANG0003) is used, the operation frequency range will cover
from 5500 to 5825MHz; if the left three antennae are used, the operation
frequency will just cover from 5745 to 5825MHz. The proper operation
frequency band shall be controlled by the professional installer through
changing the software.
(2) Any changes or modifications not expressly approved by the grantee of
this device could void the user's authority to operate the equipment.
(3) This Transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.