User's Manual

Compliance Information
FCC Compliance Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This device must accept any interference received, including interference that may cause undesired operation. Product that is a
radio transmitter is labeled with FCC ID.
FCC Caution:
(1) Exposure to Radio Frequency Radiation. This equipment must be installed and operated in accordance with provided
instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 28.37 cm
from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter. End-users and
installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure
compliance.
(2) Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate
the equipment.
(3) This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
(4) Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user
authority to operate the equipment.
RF exposure warning
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
The equipment must not be co-located or operating in conjunction with any other antenna or transmitter.
IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop configurations or co-
location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot be used on
the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including
the transmitter) and obtaining a separate FCC authorization.
The antenna gain which being use as below:
Antenna Type
Frequency
Band
(GHz)
Manufacturer
Tx
Paths
Max
Directional Gain
(dBi)
Panel Antenna 1# 5.1 ~ 5.8 Lanbowan Communications Ltd. 2 25
Panel Antenna 2# 5.1 ~ 5.8 Kenbotong Communication LTD 2 19
Panel Antenna 3# 5.1 ~ 5.8 Compex Systems Pte Ltd 2 17
Panel Antenna 4# 5.1 ~ 5.8 Compex Systems Pte Ltd 2 15
Panel Antenna 5# 5.1 ~ 5.8 Kenbotong Communication LTD 2 10
Panel Antenna 6# 5.1 ~ 5.8 Smart Ant Inc 2 7
Panel Antenna 7# 5.1 ~ 5.8 Compex Systems Pte Ltd 2 5
Panel Antenna 8# 5.1 ~ 5.8 Compex Systems Pte Ltd 2 5
Dipole Antenna 1# 5.1 ~ 5.8 Kunshan Wavelink Electronic Co., Ltd. 2 2
(1) The modules FCC ID is not visible when installed in the host, or
(2) If the host is marketed so that end users do not have straight forward commonly used methods for access to remove the
module so that the FCC ID of the module is visible; then an additional permanent
(3) 5.2GHz frequency band support the max antenna gain 25dBi, 5.8GHz frequency band support the max antenna gain 7dBi.