Network Router User Manual

Signal Strength LED Settings
LED Thresholds Configuration
The LED's for signal strength on the device can be made to light on when received signal levels
reach the values defined in the following fields. This allows a technician to easily deploy a CPE
without logging into the unit (i.e. for antenna alignment operation).
Signal LED Thresholds specify the marginal value of Signal Strength (dBm) which
will switch on LEDs indicating signal strength:
LED 1 (Red) will switch on if the Signal Strength reaches the value set in an
entry field next to it.
LED 2 (Yellow) will switch on if the Signal Strength reaches the value set in an
entry field next to it.
LED 3 (Green) will switch on if the Signal Strength reaches the value set in an
entry field next to it.
LED 4 (Green) will switch on if the Signal Strength reaches the value set in an
entry field next to it.
Configuration example: if the Signal Strength fluctuates around RSSI 15-30, the LED
Thresholds can be adjusted to the RSSI values 15, 20, 25, 30.