Network Router User Manual

Station Connection Status Info
Click at the bottom of the Status page to view client connection statistics.
WLAN Connected Status:
MAC Address: displays the MAC address of the current active WLAN card.
Signal Strength: displays the received wireless signal level of opposite connected device.
TX Rate and RX Rate: displays the current 802.11 data transmission (TX) and data reception
(RX) rate while operating in Station mode. Typically, the higher the signal, the higher the
data rate and consequently the higher the data throughput.
Channel Width:
20MHz – is the standard channel spectrum width (selected by default).
40MHz – the widest channel spectrum width required to connect to an 802.11a network which
supports Static Turbo feature
WLAN Local AP Statistics:
Bytes transmitted/received value represents the total amount of data (in bytes) transmitted
and received during the connection;
WLAN Local AP Errors: section displays the counters of 802.11 specific errors which were
registered on wireless interface:
Rx invalid NWID value represents the number of packets received with a different NWID or
ESSID - packets which were destined for another access point. It can help to detect
configuration problems or identify the adjacent wireless network existence on the same
frequency.