User's Manual

FCC WARNING

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

NOTE 1: Any changes or modifications not expressly approved by the manufacturer could

void the user’s authority to operate the equipment.

NOTE 2: The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modifications to this equipment. Such modifications could void the user’s

authority to operate the equipment.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the specific operating instructions for satisfying RF

exposure compliance.

IEEE 802.11b or 802.11g, 802.11n operation of this product in the U.S.A. is firmware-limited

to channels 1 through 11.

Antennas must be installed to provide 20 cm separation distance from the transmitting antenna

to the body of the user during normal operating condition. This device must not be co-located

or operating in conjunction with any other antenna or transmitter.

Only those antennas filed under FCC ID: TK4-10-WLE200NX can be used with this device.

When the module is installed in the final system where the antenna location is less than 20 cm

separation distance to the body of user, additional equipment authorization must be applied.

FCC ID label on the final system must be labeled with “Contains FCC ID:

TK4-10-WLE200NX” or “Contains transmitter module FCC ID: TK4-10-WLE200NX”.

In the user guide, final system integrator must be ensure that there is no instruction provided in

the user guide to install or remove the transmitter module.

Since the device operates in the 5.15-5.25GHz band, this device will be restricted to

indoor operation only in this frequency band.