User's Manual

Thank you for purchasing this Wireless Network Adapter. Data security is
facilitated with WPA, IEEE 802.1x Authentication and 64-bit, 128-bit and 152-bit
WEP (Wired Equivalent Privacy). They support easy Plug and Play installation
and combine simplicity, data privacy, and reliability for your wireless network.
Chapter 1 Basic Setup
This chapter outlines the basic requirement for the installation and configuration
of the network adapter.
This network adapter is a plug-and-play device. You can plug it into the PCI slot
of your PC for auto-detection.
1.1 Hardware Installation
1. Turn off your PC and switch off the power from the main power
supply.
2. Remove the back cover of the PC.
3. Then insert the network adapter into your PCI slot as shown below.
Ensure that the network adapter is properly seated into the slot.
4. Replace the back cover.
5. Power on your PC.